features glass passivated chip junction. high forward surgecurrent capability ideal for printed circult noard high temperature soldering guaranteed: 260 /10 seconds at 5 lbs. (2.3kg) tension mechanical data case: transfer molded plastic epoxy: ul94v - 0 rate flame retardant. terminal: lead solderable per mil - std - 202e method 208c polarity: molded on body mounting position : any weight: 0.04 ounce, 1.0 gram maximum ratings and electrical characteristics ratings at 25 ambient temperature unless otherwise specified single phase, half wave, 60hz, resistive or inductive load. for capacitive load derate current by 20% df005 DF01 df02 df04 df06 df08 df10 db101 d db10 2 db103 d104 db105 db106 db107 v rrm volts maximum rms voltage v rms volts maximum dc blocking voltage v dc volts maximum average forward rectified output current, 0.06" (0.5mm) lead length at t a = 40 (note peak forward surge current 8.3ms single half sine - wave superimposed on rated load (jedec method ) rating for fusing (t<8.3ms) i 2 ta 2 s per bridge element at 1.0a maximum dc reverse current at rate d t a = 25 a dc blocking voltage per element t a
ma typical junction capacitance (note 1 ) c j pf typical thermal resistance (note 2) r /w operating and storage temperature range t j , t stg notes: 1. measured at 1.0 mhz and applied reverse voltage of 4.0 volts. 2. unit mounted on p.c.b.with 0.51" x 0.51" (13 x13 mm) copper pads i r i fsm symbols amps (-65 to +150) unit volts maximum instantaneous forward voltage drop single-phase bridge rectifier i (av) v f maximum repetitive peak reverse voltage amp d f005-df10 http:// www.wej.cn e-mail:wej@yongerjia.com wej electronic co. r o hs wej electronic co.,ltd
t =25 c instantaneous reverse current, per bridge element revrese voltage, (v) fig.5-typical junction capacitance instantaneous forward voltage,(v) junction capacitance, (pf) v 1.0 0.1 1.0 p-p f=1mhz sig =50mv 10 t =25 c j 100 0.4 0.01 0.8 0.6 1.2 1.0 140 10 100 1.6 1.4 1.8 reverse voltage, (%) percent of rated peak 60 0 20 40 0.01 120 80 100 j 1% duty cycle pulse width=300us t =25 c fig.3-typical forward characteristics ambient temperature, ( c) output rectified current fig.1-derating curve for instantaneous forward current, 0.1 (a) j per bridge element 1.0 20 10 current , (a) average forward output single phase half wave 60hz resistive or inductive load 0 0 0.2 0.4 40 50 25 100 75 1.0 0.6 0.8 1.2 fig.2-maximum non-repetitive peak 100 fig.4-typical reverse characteristics forward surge current per element (ua) 0.1 1.0 t =125 c per bridge element 10 j 100 peak forward surge current, (a) 150 125 175 30 8 number of cycles at 60 hz 2 0 1 6 4 1 cycle 20 10 20 10 80 40 60 single half sine-wave (jedec method) 40 50 60 70 t =t j j max d f005-df10 http:// www.wej.cn e-mail:wej@yongerjia.com wej electronic co. r o hs wej electronic co.,ltd
|